Step 1: Installation 1.Install EPSONL1800 printer driver 2.Before installation, you need to connect the printer and computer with USB 3.RIP software installation and setup: Printer selection: Stylus Photo 1390/1400 4.Ink Channel selection: YKWWMC 5.White Layer Generation selection: Spot Color Step 2: Print 1.Be careful when you put the film in printer, the matte side of the film is the print side. (please protect the print side) 2.Import the picture in the software, adjust the size and location of the picture as needed. (Image in PNG format) 3.Set the canvas size, according to the size of the print. (In units cm; The bottom of the canvas needs to reserve 3-4 cm) 4.Click Mirror 5.Check Print Color First, COLOR WHITE, Click Print Step 3: Cover hot melt powder 1.After printing, try to keep the printing sheet flat when taking it out. And need to cover the printing side with hot melt powder as soon as possible. (Pour the right amount of hot melt powder into the tray, take the printing sheet from hot melt powder is inserted at the bottom; The surface of the printing sheet should be uniform and sticky hot melt powder and can gently shake off the excess hot melt powder) 2.Set the heat press machine temperature to preheat to 110-160 degrees 3.Put the printing sheet face up and spread it into the heat press machine 4.Bake for 40-60 seconds. (remember not to press the hot plate) Step 4: Transfer 1.Take out the bearing material for preheating, remove moisture and wrinkles 2.Then the print sheet is covered in the bearing area for transfer printing 3.Temperature: 110-160 degrees; Time: 8-12 seconds 4.After the T-shirt cools, open the print sheet, the transfer is completed.